RJW Series of Rolling Jacks 23 P/N 5900093 — Rev. B — October 2020
Raising and Lowering
This section describes how to raise and lower your Rolling Jack.
To raise a Vehicle on your Rolling Jack:
1. Drive the Vehicle onto the Lift.
⚠ WARNING Make sure the arms of the Rolling Jack are
fully lowered
and the Lift Pads are
removed so they do not hit the underside of the Vehicle when the Vehicle is driven
onto the Lift. If a Vehicle does hit the Rolling Jack while being driven onto or off of
the Lift, make sure the Rolling Jack has not been damaged, that all Rollers are
correctly seated on or in the Utility Rail, the Adjustment Bolts are in place and
tightened, and the Safety Brackets are in place.
2. Position the tires of the Vehicle in the center of each Runway.
3. Set the parking brake on the Vehicle and use a wheel chock to hold the Vehicle in position.
4. Check the Utility Rail Channels to make sure nothing is in them that could obstruct the movement
of the Rolling Jack.
5. Check the area to make sure everyone and everything is clear of the Lift and the Rolling Jack;
make sure there are no obstructions above the Vehicle.
6. Position the Adjustable Arms of the Rolling Jack so the Lift Pads are under the Vehicle’s axles or
contact the Vehicle manufacturer for recommended lifting points.
⚠ WARNING Make sure to raise the Vehicle on the axles or at the correct lifting points. Lifting at
the wrong location could potentially damage the Vehicle and/or the Rolling Jack.
To Next Page
Loading...
Need help?
General
