BendPak RJW Series User Manual

RJW Series of Rolling Jacks 24 P/N 5900093 — Rev. B — October 2020
7. Press and hold the PUMP end of the pedal to begin raising the Rolling Jack.
8. When the Rolling Jack reaches the desired height, release the PUMP end, then press and hold
the RELEASE end to lower the Rolling Jack onto the nearest Safety Lock.
9. Release the RELEASE end of the pump when the Jack engages on the Safety Lock (it will stop
moving down).
To lower a Vehicle:
1. Press the PUMP end for about two seconds; this raises the arms a little, moving them off the
Safety Locks.
It is difficult to move the Safety Handle out of the way if the Jack is still engaged on the Safety
Locks.
2. Pull the Safety Handle up out of the way, then press and hold the RELEASE end of the pedal.
The Rolling Jack begins lowering.
3. When the Jack is fully lowered, release the RELEASE end of the pedal.

BendPak RJW Series Specifications

General

Brand	BendPak
Model	RJW Series
Category	Jacks
Language	English