Need help?Do you have a question about the Benelli Export 3V "78" and is the answer not in the manual?
General| Front Suspension | Telescopic fork |
|---|---|
| Front Brake | Drum |
| Rear Brake | Drum |
| Gearbox | 3 speed |
| Cooling System | Air cooled |
| Transmission | Chain |
| Rear Suspension | Dual shock absorbers |
Explains the operation of switches for lights, horn, and engine stop.
Details the operation of switches for lights, horn, and turn signals.
Details the operation and positions of the lights switch.
Steps for removing flywheel cover, rotating part, chain pinion, clutch plate, and transmission gear.
Procedures for removing crankcase covers, rotor, engine pinion, and clutch assembly.
Steps for disassembling the gearbox, including removing covers and shafts.
Procedure for removing mainshaft, layshaft, and splined shaft from the crankcase.
Instructions for reassembling the gearbox, paying attention to specific component placement.
Carburettor type, control, and standard settings for Motorella and 50 Turismo.
Carburettor controls for 125 Turismo and 125 Enduro models.
Details on adjusting and lubricating the ignition rotor and checking contact points.
Wiring diagram for the G2 Elle model, showing component connections and cable colours.
Wiring diagram for Motorella, G2 KS, G2 with pedals, Magnum 3V, Export 3V.
Wiring diagram for the 50 Turismo model, detailing connections and cable colours.
Wiring diagram for the Cross model, showing component connections and cable colours.
Wiring diagram for the Magnum model, including cable colour codes.
Wiring diagram for the 125 Turismo model, detailing electrical components and cable colours.
Wiring diagram for the 125 Enduro model, showing component connections and cable colours.
To Next Page
