21
The engine oil should be between the minimum
and maximum level marks.
NOTICE
1. Start the engine, warm it up for several minutes,
and then turn it off.
2. Place an oil pan under the engine to collect the
used oil.
3. Remove the engine oil filler cap and the engine
oil drain bolt to drain the oil from the crankcase.
4. Install the washer and the engine oil drain bolt,
and then tighten the drain bolt to the specified
torque.
5. Refill with the specified amount of the recom-
mended engine oil, and then install and tighten the
oil filler cap.
TO CHANGE THE ENGINE OIL
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Wait a few minutes until the oil settles, remove
the oil filler cap,wipe the dipstick clean, insert it back
into the oil filler hole (without screwing it in), and
then remove it again to check the oil level.
4. If the engine oil is below the minimum level mark,
add sufficient oil of the recommended type to refill it
to the correct level.
5. Insert the dipstick into the oil filler hole, and then
tighten the oil filler cap. (IF EQUIPPED)
Max
Min
Type
Capacity
API SH, SAE10W40, JASO MA
1.4L ± 0.1L
To Next Page
