Beninca CP.PONY - Memorising pedestrian function (RADI>Ped); Deleting transmitters (RADI>CLR)

20
Memorising pedestrian function (RADI>Ped)
The pedestrian function can be associated to any transmitter button. The pedestrian function envisions partial opening for 7
seconds, proceed as follows:
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [5] until the Radi menu is displayed.
PMOT
Radi
2
Press the [PGM] button to enter the Radi function.
The display shows the first sub-menu PP.
Press [5] to display the Ped sub-menu.
Ped
3
Press the [PGM] button to enter the Ped function.
The display shows the flashing PUSH message.
Push
4
Press the BY transmitter button that is to be associated to the Pedestrian function within 10
seconds (e.g. if key 1 has already been associated to the Step-by-Step function, key T2 can be as-
sociated to the Pedestrian function).
5 The display shows OK to confirm memorisation.
ok
6
The control unit goes back to the RADI>PED menu. To go back to the RADI menu, press the [PGM]
and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons again at
the same time again or, alternatively, remove the power supply or wait 60 seconds.
PGM+5
Deleting transmitters (RADI>CLR)
Proceed as follows to delete a transmitter already inserted in the memory:
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [5] until the Radi menu is displayed.
PMOT
Radi
2
Press the [PGM] button to enter the Radi function.
The display shows the first sub-menu PP.
Press [5] to display the CLR sub-menu
Clr
3
Press the [PGM] button to enter the CLR function.
The display shows PUSH.
Push
4 Press any transmitter button BY that is to be deleted within 5 s.
PRG
5 The display shows OK to confirm cancellation.
OK
6
The control unit goes back to the RADI>CLR menu. To go back to the RADI menu, press the [PGM]
and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons again at
the same time again or, alternatively, remove the power supply or wait 60 seconds.
PGM+5
IMPORTANT:
CP.PONY can work with HCS (Benincà standard Rolling-code) or ARC (Advanced Rolling-code) transmitters.
The first receiver memorized will fix the receiver decoding. If for istance the first transmitter is a HCS, from then on the receiver
will work with HCS transmitters only. Erasing the receiver memory reset decoding type also.