Need help?Do you have a question about the Beninca CORE and is the answer not in the manual?
General| Motor power supply | 24 Vdc |
|---|---|
| Max. motor power | 300 W |
| Operating temperature | -20°C to +50°C |
| Protection level | IP44 |
| Power Consumption | 300 W |
| Maximum Leaf Width | 5 m |
| Protection Rating | IP44 |
| Motor Type | 24 Vdc |
| Power supply | 230 Vac |
| Safety Features | Obstacle detection |
Omnipolar switch, differential switch, earthing, power cut-off, insulation, securing leads, checking connections.
Describes wire connections shown in Fig. 1, listing terminals, function, and description.
Steps to check connections: cut power, move door, reset power, send control signal, invert motor wires if needed.
Used for setting torque, forewarning, and braking time; requires moving DIP1 to ON.
Steps to adjust braking length in opening and closing phases using PP control signal and DIP1.
Resets control unit to function without slowdowns using DIP1 and PP input or remote control.
Modifies functions of PP and STOP inputs to obtain OPEN/CLOSE or OPEN/Pedestrian inputs.
Resets receiver memory by pressing and holding P1 and P2 keys for 10 seconds.
To Next Page
