21
Remote controls quick duplication
If you have a transmitter that is already memorised (TX1), it can be duplicated (TX2) without accessing the control unit for pro-
gramming, proceed as follows:
1
Give an opening command and wait till the leaf is in full opening position using a transmitter already
stored in memory (TX1), (TCA function must be enabled ).
PMOT
2
Press the hidden key of the transmitter ,the code of which has already been stored in memory
(TX1)
TX1
3
Within 5 seconds ,press the already memorized transmitter key corresponding to the channel to be
matched to the new transmitter. The flashing light switches on.
TX1
4 Within 10 seconds ,press the hidden key of the new transmitter (TX2). TX2
5
Within 5 seconds ,press the key of the new transmitter to be matched to the channel to be matched
at the item 2 ,the flashing light switches off.
TX2
6 The receiver stores the new transmitter code and exits from the programming mode immediately.
Complete deletion of the receiver memory (RADI>RTR)
To delete the memory completely, eliminating all previously-inserted remote controls, proceed as follows:
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [5] until the Radi menu is displayed.
PMOT
Radi
2
Press the [PGM] button to enter the Radi function.
The display shows the first sub-menu PP.
Press [5] three times to display the RTR sub-menu
rtr
3
Press the [PGM] button to enter the RTR function, the RTR message starts to flash slowly.
Press [PGM], the PRG message is displayed and deleting starts.
4
When the PRG message switches off, the display shows the OK message for about 2 seconds. All
remote controls are now deleted from the memory.
PRG
6
The control unit goes back to the RADI>RTR menu. To go back to the RADI menu, press the
[PGM] and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons at
the same time again or, alternatively, remove the power supply or wait 60 seconds.
PGM+5
To Next Page
Loading...
