P
Pull to reset the automatic operat-
ing mode.
L
Pull downward to carry out the manual opera-
tion.
KEN
User’s handbook
Safety rules
• Do not stand in the movement area of the door.
• Do not let children play with controls and near the door.
• Should operating faults occur, do not attempt to repair the fault but call a qualied technician.
Manual operation from the inside
To release the automatic system and proceed to the manual operation, it is sufcient to pull the knob P
downwards. To switch to the automatic mode again, push the level L towards the door and give an impulse
control for the opening and closing of the system.
If the height at which the system is tted renders the level L difcult to reach, use another cord with knob.
Maintenance
• Every month check the good operation of the emergency manual release.
• It is mandatory not to carry out extraordinary maintenance or repairs as accidents may be caused. These
operations must be carried out by qualied personnel only.
• The operator is maintenance free but it is necessary to check periodically if the safety devices and t h e
other components of the automation system work properly. Wear and tear of some components could
cause dangers.
Waste disposal
If the product must be dismantled, it must be disposed according to regulations in force regarding the diffe-
rentiated waste disposal and the recycling of components (metals, plastics, electric cables, etc..). For this
operation it is advisable to call your installer or a specialised company.
Warning
All Benincá products are covered by insurance policy for any possible damages to objects and persons
caused by construction faults under condition that the entire system be marked CE and only Benincá parts
be used.
To Next Page
Loading...
