Need help?Do you have a question about the Bennett Marine AutoTrimPro and is the answer not in the manual?
General| Display | LED indicators |
|---|---|
| Features | LED Indication |
| Compatibility | Compatible with most trim tab systems |
| Control Method | Automatic with manual override |
| Type | Automatic Trim Tab Control System |
| Voltage | 12/24 VDC |
| Power Supply | 12/24 VDC |
| Warranty | Limited 3-year warranty |
Provides a high-level introduction to the AutoTrim Pro system and its capabilities.
Details the parts included in the AutoTrim Pro kit and optional accessories.
Guidance on preparing for the installation, including checking for existing sensors.
Step-by-step instructions for installing the helm display and control unit.
Wiring diagrams for various AutoTrim Pro system configurations and components.
Covers calibration, orientation, and angle settings for the AutoTrim Pro system.
Procedure for calibrating trim tab actuator positions for optimal performance.
Steps to orient the control unit and set idle, rest, and planing angles.
Explains the fundamental principles of how trim tabs work and their effect on boat attitude.
Describes how to use the 'All Up' and 'All Down' buttons for quick tab adjustments.
Details on setting and activating favorite positions for automatic trim tab control.
Addresses common problems encountered during system installation and initial startup.
Diagnoses issues related to the helm display not illuminating or going dark.
Troubleshoots problems with sensor detection, calibration, and flashing LEDs.
Outlines the limited warranty terms, claim procedure, and exclusions for Bennett products.
To Next Page
