ES2000 Rocker Control Installation for Hydraulic Systems
5005447 - R102219
• Before drilling any holes, read the entire instructions.
• Unsnap the bezel from the control. Using the bezel locate
the position for the control at the helm. Check carefully
to make sure there are no obstructions behind the
dashboard before drilling any holes.
• The bezel requires a footprint of 2-13/16" x 2-13/16". Cut a
2-1/2" hole in the center of the footprint using a hole saw.
• Pull the wire harness up through the hole and attach it to
the back of the control with the ring terminals enclosed.
Please make sure that the gasket is in place with the flat
side down before attaching wires to the control. There
are two screws for each wire. (The wire can be attached
to either screw.) The brass strip is marked with the first
letter of that color of the wire. All 12 screws must be in
place and snug for proper control function.
• Mark the four locations for the 7/64" pilot holes and drill.
Test fastening with the #8 screws. Open the holes to 1/8"
if necessary.
• Place the wire harness and switch in the hole with yellow
connections at top. Secure the switch plate assembly with
the enclosed #8 screws. Be sure the switch is properly
seated and snap bezel onto switch plate assembly.
• Note: The bezel will secure completely when BOW DOWN
is at the top and the switch plate assembly is mounted
with the top and bottom in proper position (yellow
connections at top).
Drilling Template
PN: ES2000
For more information on a complete hydraulic trim tab system,
please visit BennettTrimTabs.com/Hydraulic
Items Included
• Hydraulic Rocker Control
• (4) #8 screws
• (4) Ring terminals
Tools Required
• Power drill
• 7/64" Drill bit
• 2.5" Hole saw
Wiring Diagram
Have questions? We’re here to help.
Visit BennettTrimTabs.com or call (954)427-1400.
Installation Instructions
Yellow
Red
Blue
Green
7/64"
Actuators
& Tabs
HPU (Pump)
Rocker
Control
Snap-on
Bezel
Blue
Pump pressure
(Trim tabs down)
Yellow
Pump retract
(Trim tabs up)
Red
Port valve
Green
Starboard valve
Orange
Connect to 12V (+)
Must be printed or
copied at 100% scale
1"
To Next Page
Need help?
General
