Congratulations on your purchase of a Bennett SLT System —
an aordable, simple solution for small boats from 10 to 20 feet
(3 m to 6 m). Now you have the durability of a Bennett trim tab
system with a quick and easy installation. Your new Self-Leveling
Tabs (SLT) will improve your ride and boost your boat’s performance:
How they work
The SLT reacts instantly to boat speed and water pressure by adding
trim when it’s needed. At slower speeds, when the boat is trying to
get on plane, the actuators hold the trim tabs down, which lifts the
stern and simultaneously puts the boat at planing attitude. On plane,
and as the boat’s speed increases, water pressure pushes the tabs
up. You get a better ride while the SLT does all the work.
Quick and easy installation
As you will see on the following pages, installing a Bennett SLT
System can be done with just a few tools and in less than an hour.
You can also change the position of the actuator on the tab with
adjustable mounting options.
Part # Tab Size Tab Boat Size
SLT6 6" x 8"
(15 cm x 20 cm)
Up to 16’
(up to 4.9m)
SLT10 10" x 10"
(25 cm x 25 cm)
1
7’ - 20'
(
5.18 - 6m)
You selected your kit using this guideline:
If you have any questions about your kit, please contact Bennett
client service at 954.427.1400 (8 a.m. to 5 p.m. Eastern time)
or email info@BennettTrimTabs.com.
2
• Plane at lower speeds
• Improve your hole shot
• Improve fuel eciency
• Reduce engine laboring
• Reduce pounding
• Eliminate porpoising and
chine walking
To Next Page
Loading...
