14
BLOCKAGE-PROOF COVER CLEANING FLOAT VALVE CLEANING
After removing the steam plate, remove the
blockage-proof cover by pulling it outwards as
shown above.
Move the oat valve up and down gently by
hand. Rinse the seal ring of the oat valve with
water.
PRESSURE LIMITING SAFETY VALVE (VENT) CLEANING
Lift the pressure limiting safety valve body and clean it with water. Now use a steel needle or wire (less
than 3mm in diameter) to remove any deposits which may be jammed or stuck in the vent pipe. Rinse
them with water. Place the pressure limiting safety valve body on the pressure limiting safety valve seat.
Be careful not to damage the nish of the vent pipe when clearing deposits from the vent pipe.
Note that there is a release preventer on the vent valve. Lift it up slightly when taking it out. Press down
when re-installing it.
STORAGE
• Ensure that all parts are dry before storing
• Never store the appliance while it is still wet or dirty
• Store the appliance in its box in a clean, dry place
• Never wrap the power cord around the appliance
To Next Page
Loading...
Need help?
General
