Benning CM 1 User Manual

02/ 2006
BENNING CM 1 12

- Close the cover of the battery compartment and screw it into position.
- Ensure that the battery-connection wire is not crushed.
See fig. 7: Replacing the battery

Remember the environment! Do not dispose of used batteries
with domestic waste. Dispose of them at a battery-collection
point or as toxic waste. Your local authority will give you the
information you need.
9.4 Calibration
To maintain the specified precision of the measurement results, the instrument
must be recalibrated at regular intervals by our factory service. We recommend
a recalibration interval of one year. Send the appliance to the following
address:
Benning Elektrotechnik & Elektronik GmbH & CO. KG
Service Centre
Robert-Bosch-Str. 20
D - 46397 Bocholt
10. Environmental notice
At the end of the product’s useful life, please dispose of it at
appropriate collection points provided in your country.

Benning CM 1 Specifications

General

Data hold	Yes
Jaw opening	30 mm
Safety	CAT III 600 V
AC voltage range	0.1V to 600V
DC voltage range	0.1V to 600V
AC current range	0.1A to 600A
Power Supply	2 x AAA batteries