DSP 2500 Inverter System
10.15.07 21 028-0009-200
10. Installation of the Unit
Attention!
The inverter should be free of voltage before installation. If
the DC supply is connected it must be disconnected be for
continuing installation.
Attention!
For adequate ventilation the front of the unit has to be
unobstructed. The rear of the unit requires at least 6 inches
of clearance.
.
Mounting in Cabinet (4 post)
Install the inverter into the cabinet using slide rails or shelf for support. Secure
inverter module to cabinet using holes provided on the face plate of the module.
Attention!
The faceplate of the inverter has not been designed to
support the weight of the module.
To Next Page
Loading...
