16 How to assemble your monitor hardware
To Connect the DP Cable
Connect the plug of the DP cable to the monitor video
socket. Connect the other end of the cable to the
computer video socket.
After the monitor is powered on, if the image is not
displayed, disconnect the cable. Go to
System and
DisplayPort on the OSD menu of the monitor and change
the setting from
1.2 to 1.1, and then connect the cable again.
To go to the OSD menu, see Basic menu operation on page
33.
If there is more than one video transmission method
available to you, you might want to take the picture quality
of each video cable into consideration before making the
connection.
- Better quality: HDMI / DVI-D / DP
- Good quality: D-Sub
The video cables included in your package and the socket
illustrations on the right may vary depending on the product
supplied for your region.
Or
3. Connect the audio cable.
Connect the audio cable between the socket on the
rear of the monitor (Line In) and your computer audio
outlet.
You may connect headphones to the headphone jack
found on the back side of the monitor.
To Next Page
Loading...
Need help?
General
