BenQ DC 2300 - Setup Mode Configuration Options

BenQ DC 2300 User’s Manual
13
3.1.4. Set Up Mode
Please set the Mode Dial at Set Up Mode ( ) and press Menu
Button to enter "Set Up" menu table. Use Up Direction Button
( ) and Down Direction Button ( ) to move the color bar to
the feature you would like to set up. Press Right Direction Button
( ) to enter the setting and select your preferred setting using
Up ( ) and Down ( ) Direction Buttons.
Press Right Direction Button ( ) to confirm the new setting or
press Menu button to cancel the setting. When the LCD Display
is back to the "Set Up" menu table, please check if the new setting
is shown on the right side of the LCD screen. If the new setting is
not shown please repeat the above procedure.
I. Set Up Beep Sound (Preset at On)
Please set the Mode Dial at Set Up Mode ( ) and press Menu Button to enter
"Set Up" menu table.
1. Select "Beep".
2. Press Right Direction Button ( ).
3. Select "On" to activate the beep sound or select "No" to cancel
the beep sound.
4. Press Right Direction Button ( ) to confirm the setting.
II. Set Auto Power Off (Preset at Cancel)
1.Select "Power Off".
2. Press Right Direction Button ( ).
3. Select the time of auto power at "5 minutes" or "10 minutes". Or select
"Cancel" to cancel auto power off function.
4. Press Right Direction Button ( ) to confirm the setting.
III. Set Date Stamp (Preset On)
1. Select "Date Stamp".
2. Press Right Direction Button ( ).
3. Select "On" to activate date print or select" Off" to cancel date imprint.
4. Press Right Direction Button ( ) to confirm the setting.