BenQ DC 2300 User’s Manual
3
2. P
REPARING
YOUR
DC 2300
FOR
USING
2.1. How to Switch On or Switch Off The Camera
To switch on the camera, slide the Power Switch to the side and
hold for 1 second. To switch off the camera, slide the Power Switch to the side and
hold for 1 second again.
Load the Batteries:
This camera is using 2 pcs of AA battery.
1. Make sure the camera is switched off.
2. Open the Battery / Memory Card Cover.
3. Load the batteries into the battery chamber following the
polarity indications.
4. Close the Battery / Memory Card Cover.
Note
On the TFT LCD Monitor you can see the battery status as below:
( ) Batteries are with sufficient electricity power to support the camera's operations.
( ) Battery power half drained, please prepare with new batteries.
( ) Batteries drained. Replace the old batteries with new ones.
Note
Please use the below suggested battery to ensure that the battery is
of acceptable quality to support the camera's operation:
Brand Model no. Type
Duracell Ultra MX1500 Alkaline
Note
1. Batteries may lose power if kept inside the camera for a long time without using.
Please remove the batteries while the camera is not in use.
2. Do not use manganese batteries as they cannot supply sufficient power to support
the camera's operation.
3. Batteries may not work normally under 0ºC.
4. It's normal that the temperature of the camera body rises after being in use for a long
period.
To Next Page
Loading...
Need help?
General
