BenQ DC 2300 User’s Manual
19
The battery power is draining
quickly.
• The extemal temperature is too
cold.
• The camera is using both old and
new batteries.
• Keep the camera away from
extreme temperatures.
• Replace all batteries with new
ones.
The camera does not take pic-
tures when the shutter button
is pressed .
• The camera is not set at
Recording Mode.
• The batteries are weak.
• The power has not been
switched on.
• Set the Mode Dial at Recording
Mode.
• Replace the batteries with new
ones.
• Switch on the power.
The image is blurred. • You have selected the incorrect
focus range.
• If the subject is about 18~25 cm,
select macro mode.
• If the subject is about 80~130
cm, select portrait mode.
• If the subject is beyond 130 cm,
select normal mode.
The flash does not fire. • The camera flash is turned off. • Set the flash mode to Auto Flash
or Fill-in Flash mode.
Incorrect date/time is
displayed.
• Reset Date/Time.
Camera fails to work by any
button or switch.
• Removed the batteries and
reload them.
There is something wrong
with the color of the captured
image.
• White Balance is not set
properly.
• Reset white balance.
The picture is too bright or
too dark.
• There is excessive exposure. • Reset exposure compensation.
The TFT LCD monitor is not
clear.
• The LCD monitor plastic cover
is dirty.
• You should clean the LCD cover.
The camera cannot download
images to the PC.
• Cable is not connected properly.
• Camera is off.
• There are no batteries or the
adapter is not well connected.
• OS is not Window 98/98SE /
2000/ME/XP or PC is not
equipped with USB port.
• USB driver is not installed.
• Check the cable connection.
• Turn on the power.
• Load new batteries or check the
AC power adapter connection.
• Install Windows 98/98SE/2000/
ME/XP and USB Port.
• Install USB Driver.
To Next Page
Loading...
