22 Operation
Likewise, when you wish to switch from the Advanced OSD menu to the Basic OSD menu, follow
the instructions below:
1. Go to System > Menu Settings > Menu Type and press OK.
2. Press / to select Basic. Your projector will switch to the Basic OSD menu.
Securing the projector
Utilizing the password function
Setting a password
1. Go to Advanced menu - System > Security Settings > Password. Press OK. The Password
page appears.
2. Highlight Change Password and press OK.
3. The four arrow keys ( , , , ) respectively represent
4 digits (1, 2, 3, 4). According to the password you
desire to set, press the arrow keys to enter six digits for
the password.
4. Confirm the new password by re-entering the new
password.
5. To activate the Power On Lock function, go to
System > Security Settings > Password > Power
On Lock, press OK and / to select On. Input the
password again.
• The digits being input will display as asterisks on-screen. Make a note of your selected password and keep it in a
safe place in advance or right after the password is entered so that it is available to you should you ever forget it.
• Once a password has been set and the Power On Lock is activated, the projector cannot be used unless the
correct password is entered every time the projector is started.
To Next Page
