43 Menu operation
Warping
• Warping Background
Choose Yes if you want to set the warping data with your projected image. If not,
a black screen will be displayed.
• Warping Correction
If you have never set the warping data under the selected warping pattern, a grid
pattern is displayed.
1. Press / / / to move the cursor to an adjustment point.
2. Press OK.
3. Press / / / to move the adjustment point up/down/left/right. Short
press on the directional arrow moves 1 pixel, while long press moves 30
pixel.
The adjustment data will be saved and can be loaded the next time you select the
same warping pattern.
• Reset
If you want to set a new warping data for the selected pattern, reset its data first
by choosing Reset.
Image Memory
• Save Image Memory: Allows you to save and apply several sets of image
settings for regularly used circumstances, including the following settings:
Projector Installation, Aspect Ratio, Picture Mode, Source, Resolution,
Light Source Mode, Digital Shrink & Shift, Blanking. You can choose one
set of memory to save the current settings.
• Apply Image Memory: After the image memories are saved, you can decide if
you would like to apply it by choosing a set of memory that you have saved.
• Rename: Renames the image memories.
To Next Page
