BenQ LX810STD - Page 12

Introduction12
Remote control effective range
Infra-Red (IR) remote control sensors are located on the front and the rear of the
projector. The remote control must be held at an angle within 30 degrees perpendicular to
the projector's IR remote control sensors to function correctly. The distance between the
remote control and the sensors should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensors on
the projector that might obstruct the infra-red beam.
16. Right/
Increases the projector volume.
When the On-Screen Display (OSD)
menu is activated, the #3, #5, and #16
keys are used as directional arrows to
select the desired menu items and to
make adjustments.
17. SOURCE
Displays the source selection bar.
18. MIC/VOL+/MIC/VOL-
(No function.)
19. MUTE
Toggles projector audio between on and
off.
20. ASPECT
Selects the display aspect ratio.
21. SMART ECO
Displays the Light Source Mode menu
for selecting a suitable light source
operating mode.
22. Numeric buttons
Enters numbers in network settings.
Operating the LASER pointer
The Laser Pointer is a
presentation aid for
professionals. It emits red
colored light when you press
it.
The laser beam is visible. It is
necessary to press and hold
LASER for continuous
output.
Do not look into the laser light window or shine
the laser light beam on yourself or others. See
the warning messages on the back of the remote
control prior to using it.
The laser pointer is not a toy. Parents should
be mindful of the dangers of laser energy and
keep this remote control out of the reach of
children.
• Operating the projector from the
front
A
p
p
r
o
x
.
+
3
0
º
• Operating the projector from the
rear
A
p
p
r
o
x
.
+
3
0
º