24 Operation
8. Press BACK to exit the menu.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby mode, you
can use any computer that is on the same local area network to control the projector.
1. Enter the address of the projector in the address bar of your browser and click Go.
2. The remote network operation page opens. This page allows you to operate the projector as if you
were using the remote control or control panel on the projector.
The tools page allows you to manage the projector, configure the Network settings and secure
access of remote network operation on this projector.
i. You can name the projector, keep track of its location and the person in charge of it.
ii. You can adjust the Network settings.
• Menu (MENU) • Back (BACK) See Controls and functions on page 9 for details.
• OK • Input (SOURCE)
• ( ) • ( )
• •
• Blank (ECO BLANK)
To switch input source, click on your desired signal.
The source list varies according to the connectors available on the projector. ''Video'' stands for the Video signal.
To Next Page
Loading...
