Positioning your projector20
WUXGA
Notice (when edge blending)
• To avoid the image shaking or some pixels in the display may be misaligned, do not use
the projector in the following location:
• In a building close to a construction site.
• In a room where an air conditioner unit is working and it vibrates.
• In a place where the temperature changes dramatically that may cause thermal
contraction.
• Before making any adjustment, leave the projector lit for at least 45 minutes after its
lamp is turned on. This allows he internal temperature of the projector to stabilize.
Desk-Front Projection
Ceiling Mount-Front Projection
Vertic al shift
Height of projected image
Max 0.15V
Max 0.55V
Height of projected image
Vertic al shift
Vertical shift
Normal projection position
Width of projected image
0.05H 0.05H
1V
1V
1H
Shift to Left
Shift to Right
Max
0.55V
To Next Page
