1English
For Your Safety
• Use only the supplied USB power cable and connect only to USB port power (5V DC, 1A).
Otherwise the lamp will fail to work normally or result in a fire hazard.
• In order to prevent any damages to the lamp, do not hang or place any objects on the lamp.
• Route the USB power cable so as to avoid it from being pinched by items placed upon it or
against it.
• If the lamp will not be used for a long period of time, unplug it from the USB port.
• The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person.
Using the Lamp
Turning on/off the Lamp and Entering Auto Dimmer Mode
• Do not block the light sensor on the controller. Otherwise the Auto
Dimmer Mode will not function properly.
• The Auto Dimmer Mode will be canceled and the Auto Dimmer Mode
indicator will go off when you adjust brightness or color temperature.
Adjusting Brightness and Color Temperature
• In case of the following situations, unplug the lamp from the USB port
immediately and contact the authorized service center or a qualified service
person for inspection or repair:
- When the outer casing of the lamp is broken
- When there are strange odors coming from the lamp
- When the LED light source flickers
- When the insulation of the lamp’s wiring is damaged or frayed, and the metal
strings inside can be seen
• Do not use the lamp in a humid environment (like in a bathroom or outdoors).
Otherwise the components inside may short-circuit and result in accidents.
• This lamp is designed for indoor use only. Do not use it outdoors.
• Never disassemble the lamp or remove any components from it, as doing so
may result in accidents and will void the product warranty.
Tu r n i n g o n / o f f t h e L a m p
To turn on the lamp, press the knob on the controller. To turn off
the lamp, press the knob again.
Entering Auto Dimmer Mode
To enter Auto Dimmer Mode, press the Auto Dimmer Mode
button on the controller when the lamp is on. The Auto
Dimmer Mode indicator will light up. The Auto Dimmer Mode
automatically adjusts the lamp’s brightness according to the
ambient lighting condition and optimizes the color temperature
setting for reading.
Auto Dimmer
Mode
indicator
Adjusting Brightness
When the lamp is on, press the Color temperature/Brightness
selection button on the controller. When the Brightness
adjustment indicator lights up, turn the knob clockwise to
increase brightness, or counter-clockwise to decrease it. You can
select from 15 brightness levels.
Brightness
adjustment
indicator
Color
temp.
adjustment
indicator
Color
temp./
Brightness
selection
button
To Next Page
Loading...
Need help?
General
