34 Adjusting the screen refresh rate
Adjusting the screen refresh rate
You don’t have to choose the highest possible refresh rate on an LCD display, because it is not
technically possible for an LCD display to flicker. The best results are obtained by using the factory
modes already set in your computer. Check next chapter to see the factory modes: Preset display
modes on page 35.
You can choose 59.934 Hertz for the native resolution of 1920 x 1080. Not applicable in all models. Please
refer to the table on page 33.
1. Double click the Display icon in Control Panel.
2. From the Display Properties window, select the Settings tab and click the Advanced
button.
3. Select the Adapter tab, and select an appropriate refresh rate to match one of the applicable
factory modes as listed in the specification table.
4. Click Change, OK, then Yes.
5. Close the Display Properties window.
To Next Page
Loading...
