BENSON OLYMPIC WH - Page 43

46 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

10.0 Introduction

The

following

informatio

n is

relevant

to the

Olympic

WH

Cabinet

Heater

range

manufactured

by

Benson

Environmental

Ltd.

These

heaters

are

manufactured

\vithin

a strictly

controlled

quality

system

to ISO

900l.

AU

Benson

Environmental

Ltd

gas

fired

Cabinet

Heaters

are

CE

marked,

having

been

independently

tested

and

found

to

satisfy

the

essential

requirements

of

the following

European

Directives.

Gas

Appliance

Directive

(90/396/EEC)

Machinery

Directive

(89/392/EEC)

Low

Voltage Directive

(73/23/EEC

&

93/68/EEC)

Electromagnetic

Compatibility

Directive

(89/336/EEC

&

91/31/EEC)

Product

Liability Directive

(65/374/EEC)

Benson

Environmental

Ltd

support

all

new

products

being

supplie

d to

their

customers

with

a

comprehensive

information

pack,

and

it is

the

responsibility

of

the

owner,

user,

or

hirer, of

such

products

supplied

by Benson

Environmental

Ltd

to

ensure

that

operators

are

provided

with

the

operator

manual,

and

that

they

are

suitably

instructed

regarding

the

purpose

of

the

manual

and

safety instructions.

In

addition

to this,

operators

must

also be

suitably

and

adequately

trained

in the

lise

of

the

product.

Contained

with

the

text

of

this

manual,

the

words

'Caution'

and

'Warning'

are

used

to

highlight

certain

points.

Caution is

used

when

failure to follow

or

implement

the

instruction(s)

can

lead

to a

premature

failure

or

damage

b

eing

occasioned

to the

heater

or

its

component

parts.

Warning is

used

when

failure to

heed

or

implement

the instruction(s)

can

lead

not

only

to

component

damage,

but

can

also lead to a haz

ardous

situation

being

created

where

there is a risk of

personal

injury

or

death.

10.1

Commissioning

and

hand

over

Warning

As

part

of

the

commissioning

programme,

the

commissioning

engineer

must

go

through

the

following

with

the

operator.

(i)

Lighting,

shutdown,

and

operational

information.

(ij) Safety features,

data

plate,

and

labelling.

(iij)

The

requirement

for

regular

inspection

- especially if

the

heater

is

within

a

more

demanding

environment

-

and

the

need

for

regular

servicing,

carried

out

by

competent

and

qualified

engineers.

Table of Contents