BENSON OLYMPIC WH - Stop Procedure; Shutdown Procedure; Lockout Situations; Contact Information

10.4 Stop procedure
(a) Set on/ off switch to 'off' position.
(b)
The fan motor will continue to run until heat dissipation allows the fan and
limit stat to shut down the fan.
Caution
Do not use the main electrical isolator to turn off the heater, to do so can cause
damage to the heat exchanger and combustion chamber, and thereby invalidate
the warranty.
10.5 Shut down procedure
(a) Follow steps 10.5 (a) and (b), when fan stops turn main electrical isolator off,
and shut gas cocks.
10.6 Ventilation only
(a) Set heat/ventilate switch to 'ventilate'.
(b) Set
on/off switch to 'on'.
10.7 Lockout situations
If either the burner or the fan and limit stat go to lockout, the lockout must
be cleared manually before the ignition sequence can be re-initiated.
Caution
Repeated or frequent lockouts must be investigated and their cause
determined by a qualified and competent engineer .
Warning
If a gas leak is suspected, all potential sources of ignition must be
extinguished, gas supply cocks closed to isolate the leak, doors and windows
opened to allow the dissipation of the gas to occur, and the gas supplier
informed immediately.
N
ever search for gas leaks with a naked flame.
10.8 Contact information
Further information is available from ;-
BENSON ENVIRONMENTAL LIMITED
LUDLOW ROAD, KNIGHTON, POWYS LD7 1LP
Telephone: 01547 528534 Facsimile: 01547 520399