bentrup TC88 - User Manual

Bedienungsanleitung
Operating Instructions
Die neue bentrup Kompaktserie. Perfektion vom Marktführer.
TC 66
TC 88
TC 44

bentrup TC88 Specifications

General

Category	Controller
Input Voltage	24V DC
Number of Outputs	8
Protection Class	IP20
Operating Temperature	0 to 50°C

Summary

Introduction to Bentrup Compact Series Controllers

Bentrup TC44 Programme Controller

TC44: Adjusting and Starting a Firing Process

Guide to setting heat-up rate, temperature, and starting a firing.

Bentrup TC66 Programme Controller

TC66: Storing and Managing Firing Programmes

How to save and manage up to 6 firing curves as programmes.

TC66: Selecting and Starting a Pre-set Programme

Steps to choose and initiate a saved firing programme.

TC66: Modifying Firing Curve Parameters

How to change temperatures and other settings in existing programmes.

TC66: Programme Delay and Firing Monitoring

Setting delayed starts and observing firing progress.

Bentrup TC88 Programme Controller

TC88: Creating and Saving Firing Programmes

Guide to programming firing curves with up to 10 segments.

TC88: Starting and Observing the Firing Process

How to start a firing and monitor its status and progress.

TC88: Setpoint, Remaining Time, and Manual Control

Displaying setpoints, remaining time, and manual process adjustments.

Additional Information and Error Messages

Troubleshooting: Understanding Error Messages

Explanations of common error codes and their causes.

Controller Operating Parameters and Settings

Electrical Connections and Details