Bergstrom H295 - Operation Instructions; Adding Water

Deluxe Peltier Air Cooler H295 Instructions for Use
Please read and retain these instructions for future reference v001: 28/09/20
Page No. 4
OPERATION INSTRUCTION
1. Pull the unit outwards from the carton and place it on a solid heat-proof level surface.
2. Unpack the components carefully. Please check all parts have been removed from the packaging.
3. Place the unit on a solid heat-proof level surface. Take out the casters and caster wrench to assemble.
4. Note: casters with skid are for the two front holes and casters without skid are for the two back holes at
the bottom of the unit. (shown as figure.1)
Add water:
Pull the water tank upwards and pull outwards about 10cm to the locking pin, then add water. (shown in
figure.2)
Note:
The water level must be between the min and max line. (shown in fig.3)
After some time of operation, dust and dirt may occur in water tank. It is recommended to change the water
and clean water tank frequently.
Fig. 1
Fig. 2
Fig. 3