Berner BHPC 150-1 - 4.4 Mounting High Pressure Hose; 5 Operating Your Pressure Washer; 5.1 Mounting the Spray Lance; 5.2 Water Connection

BHPC 150-1 4-in-1 Lance
DE
EN
I
T
ES
FR
NL
DA
SV
FI
NO
34
Original Instructions
PT
4.4 Mounting of high pres-
sure hose
Unwind the high pressure hose
completely.
Attach the high pressure hose
(3) to the spray handle (6).
5 Operating your pressure washer
5.1 Mounting of spray lance 1. Pull the blue quick-release
grip (A) of the spray gun
backwards.
2. Insert the nipple of the spray
lance (B) into the quick-re-
lease connection and release
it.
3. Pull the spray lance (or other
accessory) forwards to check
that it is securely attached to
the spray gun.
5.2 Water connection IMPORTANT! Only use wa-
ter without any impurities. If
there is a risk of silt, sand or
sediment in the inlet water (i.e.
from your own well), an addi-
tional fi lter should be mounted.
1. Let the water run through the
water hose before connecting
it to the machine to prevent
sand and dirt from penetrat-
ing the machine.
Note: Check that the fi lter is
fi tted in the water inlet pipe
and that it is clean and free
from debris.
2. Connect the water hose to
the water supply by means
of the quick connector (inlet
water, max. pressure: 10 bar,
max. temperature: 60°C).
3. Turn on the water.
A
B
NOTE!
Always remove any dirt from
the nipple before connecting the
spray lance to the spray handle.
An ordinary 1/2" garden hose of
min. 10 m and max. 25 m will
be suitable.
NOTE: Connec-
tion to the public
mains according
to regulations.