Berner BI4EGV32 - Installation Instructions for Build-in (Sensor Touch Ver. B)

Page 36 of 44 17.07.2014
Ver. 3.3 © Berner Kochsysteme 2015
Applying a thin layer Pactan on the inner frame to fix the
glass ceramic plate
. Be careful in range of the display, to
protect
the display segment.
Place
the glass ceramic plate in the fresh Pactan layer on
the inner frame. Make sure that the displa
y didn`t get in
contact
with the Pactan.
Place
the glass ceramic plate in the center.
(
All around approx. 3 mm distance).
Important
: The weight has to be higher than the Spring
tension
of the coil to keep the glass ceramic plate on the
inner frame
. Keep the weight on the place until the
adhesive is cured
.
To adjust
the glass ceramic plate to the same level like
the surface,
use the adjustable screws on the mounting
frame and secure the screw with the nut.
Important
: Please secure the screw with the lock nut.
Fill the place between the glass ceramic plate and surface
with
excess pactan.
Important
: Please use in range of the display less
material to prevent the display from
contact with the
adhesive
.
Spray the
Pactan fuge wet with wet agent and remove
the
excess pactan with a suitable tool.
Important
: Drying time is approx. 24 hours for 1 mm
fuge thickness
!