Setting up the machine
44
> Guide the thread straight to the thread guide and down.
> Open the service door and check whether the thread is positioned between the two front thread tension
discs. If not, repeat the previous step.
> Close the service door.
> Guide the thread on the right-hand side of the machine in the direction of the arrow through the thread
regulator.
> Guide the thread up and thread into the take-up lever from the back to the front.
> Guide the thread down and into the right opening of the thread guide underneath the service door (1).
> Guide the thread from the right into the thread guide on the needle bar (2).
To Next Page
