Berrcom JXB-182 - Page 11

11
electromagnetic immunity of this equipment and result in improper operation.”
Warning: Portable RF communications equipment (including peripherals such as antenna cables and
external antennas) should be used no closer than 30 cm (12 inches) to any part of the equipment
JXB-182, including cables specified by the manufacturer. Otherwise, degradation of the performance
of this equipment could result.
1， All necessary instructions for maintaining BASIC SAFETY and ESSENTIAL PERFORMANCE with
regard to electromagnetic disturbances for the excepted service life.
Portable and mobile RF communication equipment may affect the performance of the JXB-182,
avoiding strong electromagnetic interference when used, such as near mobile phones, microwave
ovens, etc.
2， Guidance and manufacturer’s declaration -electromagnetic emissions and immunity
Guidance and manufacturer’s declaration -electromagnetic emissions and immunity
Table 1
Guidance and manufacturer’s declaration - electromagnetic emissions
Emissions test
Compliance
RF emissions
CISPR 11
Group 1
RF emissions
CISPR 11
Class B
Harmonic emissions
IEC 61000-3-2
No aplicación
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
No aplicación
Table 2
Guidance and manufacturer’s declaration - electromagnetic immunity
Immunity Test
IEC 60601-1-2
Test level
Compliance level
Electrostatic
discharge (ESD)
IEC 61000-4-2
±8 kV contact
±2 kV, ±4 kV, ±8 kV,
±15 kV air
±8 kV contact
±2 kV, ±4 kV, ±8 kV, ±15
kV air
Electrical fast
transient/burst
No application
No application