DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK • The water tank is empty or
positioned incorrectly.
• Fill the tank with water
and/or insert it correctly,
pushing it as far as it will
go.
GROUND TOO FINE ADJUST
MILL AND
(alternating with)
PRESS OK
• The grinding is too fine
and the coffee is delivered
too slowly.
• The machine cannot make
coffee as there is air in the
hydraulic circuit
Possible cause: the filter
has not been installed cor-
rectly.
• Turn the grinding adju-
stment knob one click
clockwise towards "7".
• Make sure the filter (A25)
is propertly installed and
that the installation has
been carried out correctly.
EMPTY WASTE COFFEE
CONTAINER
• The waste coffee contai-
ner (A4) is too full or
more than 3 days have
passed since you last
made coffee (this guaran-
tees correct hygiene of the
machine).
• Empty the waste coffee
container and clean, then
replace.
Important: when remo-
ving the drip tray, the
waste coffee container
MUST be emptied, even if
it is not completely full.
If this is not done, when
you make the next cof-
fees, the waste coffee
container may fill up more
than expected and clog
the machine.
GROUND TOO FINE ADJUST
MILL AND
(alternating with)
PRESS OK
(then)
FILL TANK
• The tank has been remo-
ved during delivery.
• Insert the tank and press
the icon (B9). "HOT
WATER PRESS OK" is di-
splayed. Press the
icon (B9) again.
The appliance is once
again ready for use.
INSERT WASTE COFFEE
CONTAINER
• After cleaning, the waste
coffee container has not
been replaced.
• Open the service door and
insert the waste coffee
container.
24
GB
To Next Page
Loading...