Need help?Do you have a question about the Besam ASSA ABLOY Swingmaster 900 and is the answer not in the manual?
Crucial installation instructions, safety warnings, and radio interference advice.
Details power supply, consumption, fuse, breaker, door weight, and ambient temperature.
Explains the operator's function, opening, and closing mechanisms.
Outlines circuit functions like kill, locks, push/go, and power failure safety.
Covers presence detection, OPD, and panic egress safety functions.
Defines how to determine and set the correct handing for door and operator.
Provides a guide for selecting the appropriate spring based on door specifications.
Identifies parts for the Swingmaster 900 Surface Mount configuration.
Identifies parts for the Swingmaster 900 Concealed Mount configuration.
Details push, pull, and concealed arm systems and their components.
Covers operational switches and safety signage requirements for the doors.
Differentiates between Side Load, Bottom Load, Concealed, and Surface Applied installations.
Covers general tips, safety concerns, and a summary of installation steps.
Lists required fasteners, test equipment, and tools for installation.
Details cam adjustments and changing the operator's handing for setup.
Guides for concealed operators on center-pivot doors and finding pivot height.
Steps for installing the header and operator in installed or uninstalled frames.
Introduces surface mount operators and the push/pull arm systems.
Details the procedure for mounting the header for surface applications.
Covers 120V power connection and wiring the CU2 control unit.
Specific setup for paired doors requiring two CU2 controls for synchronization.
Guides on adjusting potentiometers for speed, hold, ramp, back check, and time delay.
Explains the purpose and adjustment of each potentiometer for fine-tuning.
Excerpts related to swinging doors, guide rails, and sensor requirements.
Specifies requirements for activating zones and safety zones for sensors.
Details standards for entrapment protection, door signage, and maintenance.
Specifies requirements for "AUTOMATIC DOOR" and "DO NOT ENTER" signs.
Provides solutions for common problems like door not starting or not closing properly.
Addresses common installation queries, such as mounting distance and arm slipping.
Outlines maintenance checklist and lists available spare parts for the operator.
Shows wiring charts for CU2 backward compatibility with LO21B and Passport Plus.
Provides detailed wiring schematics for Swingmaster CU2 master and slave configurations.
General| Brand | Besam |
|---|---|
| Model | ASSA ABLOY Swingmaster 900 |
| Category | Door Opening System |
| Language | English |
To Next Page
