Best Divers Becam 4K EIS - Time Lapse Mode

18
EN
tedly until it appears. In Burst Photo mode, your camera takes
3 photos in 1.5 seconds.
To take a Burst Photo series:
Press the Shutter/Select Button the camera will emit camera
shutter sounds.
To capture a Time Lapse series, verify the camera is in Time
Lapse mode. If the Time Lapse icon on your camera’s LCD
screen is not showing, press the Power/ Mode Button repea-
tedly until it appears. In Time Lapse mode your camera captu-
res a series of photos at 2,3,5,10,20,30 or 60 seconds intervals.
To take Time Lapse:
Press the Shutter/Select Button. The camera initiates
countdown and emits the camera shutter sound each time a
photo is taken.
1. Verify the camera is in Camera Mode.
2. Press and hold the Shutter/Select Button for three seconds.
3. Repeatedly press the Power/Mode Button to cycle through
camera modes.
4. Press the Shutter/Select Button
5.To exit: hold down the Shutter/Select Button for three se-
conds.
The Ez iCam APP (4k & 2.7K not supported) lets you
TIME LAPSE MODE
QUICK MODES
CAMERA APP