BestCode Next 8 Series - Makeup Fluid Management; When to Add Makeup; How to Add Makeup

Heavy Pigment fluids must
be shaken for 1 to 2 minutes
to ensure that the pigment is
suspended in the fluid and
not caked to bottle. Failure
to shake to bottle will result
no pigment being in the tank.
This will make faint print that
is not bright.
7. Remove the Ink bottle, and remove the
cap
8. Insert the bottle and press firmly to
break the foil seal
9. Wait for 1-2 minutes for the bottle to
drain
10. Discard the empty ink bottle in
accordance with local regulation.
11. Press OK on the Success screen pop-up
(10-0001)
When to Add Makeup
The BestCode Next Series 8 CIJ will allow a
Makeup bottle to be added when the Float
switch in the Makeup Tank is in the OK state.
The BestCode Next Series 8 CIJ will begin
requesting a Makeup bottle be added when the
Makeup float switch in the Makeup Tank is in the
low state.
An on-screen pop-up Makeup Warning, 11-0003
will occur every 6 minutes while the Makeup
Tank is in this State.
When the Makeup float switch is in the low
state, 15 Makeup Adds will be allowed, and then
a Makeup Fault 11-0002 will occur.
The Jet cannot be started again until a new
bottle of SmartFill Makeup is added.