BestCode Next 8 Series

Other manuals for BestCode Next 8 Series

Questions and Answers

Mark HubbardAug 5, 2025

What to do if my BestCode Next 8 shows a Gutter Fault?

W
William JohnstonAug 5, 2025
If your BestCode printer displays a Gutter Fault, several issues could be the cause. First, if fluid isn't detected in the gutter, perform Backflush Nozzle then start jet, repeating up to seven times. Also, ensure the jet is entering the gutter and that the printhead is clean. A clogged gutter line could also be the problem; inspect the valve, gutter detect, venturi, and printhead gutter for any clogs or obstructions, cleaning each component and replacing them if necessary. A bad jet alignment can also cause this problem, so perform a nozzle alignment. Finally, if ink isn't jetting from the nozzle, check the nozzle, drop generator, 3-way valve, 3-way valve manifold, dampener, and main ink valve for clogs or obstructions, cleaning each component and replacing if needed.

Caleb WilsonAug 20, 2025

What to do if my BestCode Next 8 shows a Shut Down message?

M
Marisa CunninghamAug 20, 2025
If your BestCode printer prompts you to Shut Down, you can either press OK to shut down the machine or press Cancel to close the prompt.

Summary

General Safety Precautions

Personal Injury Safety

Guidelines for preventing personal injury when handling inks, solvents, and fluids.

Equipment Damage Prevention

Precautions to prevent damage to the printer from fluids or improper use.

Fire Hazard Prevention

Safety measures regarding flammable inks and solvents.

Electrical Shock Prevention

Measures to avoid electrical hazards during printer operation and servicing.

Installation and Setup

Grounding and Power Cord Safety

Essential grounding and power cord requirements for safe printer operation.

Ideal Mounting Procedure

Instructions for the ideal setup and positioning of the printer.

Printhead Mounting Procedure

Procedure for correctly securing the printhead for operation.

Printer Operation

Power On and Off

Steps for turning the printer on and off.

Start and Stop Jet

Procedure for starting and stopping the printing jet.

Selecting Print Messages

How to select and apply print messages to the output.

Ink Management

When to Add Ink

Indicators and conditions that signal the need to add ink.

How to Add Ink

Step-by-step guide for refilling the ink reservoir.

Makeup Fluid Management

When to Add Makeup

Indicators and conditions that signal the need to add makeup fluid.

How to Add Makeup

Step-by-step guide for refilling the makeup fluid reservoir.

Maintenance

Backflush Nozzle Procedure

Steps for cleaning the printhead nozzle using the backflush function.

BestCode Next 8 Series Specifications

General

Technology	Thermal Transfer / Direct Thermal
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Technology	Thermal Transfer / Direct Thermal
Print Speed	Up to 8 IPS (203 mm/s)
Resolution	203 DPI (8 dots/mm)
Maximum Print Speed	8 IPS
Electrical Requirements	100-240V AC, 50/60Hz
Max Print Width	104 mm (4.09")
Connectivity	USB, Serial, Ethernet
Memory	64MB SDRAM
Supported Media Types	Label
Media Width	25.4 mm to 110 mm
Media Thickness	0.07 mm to 0.2 mm
Peeler Option	Optional
Cutter Option	Optional
Storage Temperature	-40°F to 140°F (-20°C to 60°C)

BestCode Next 8 Series - User Manual