3.
Battery removal and installation.
Remove the battery
How to ride
Install the battery
1.
Unscrew the pedal cover
screw counterclockwise.
4.Lift the battery strap and
take out the battery.
2.
Lift the pedal cover from
the quick-release screw on
the rear wheel side.
3.
Unplug the charging plug
and the power plug of the
controller.
1.
Wear helmets and other protective equipment before riding.
2.
Long-Press the power button to turn on scooter, stand on the pedal with
one foot, press the accelerator, and push the other foot back on the ground.
1.
Put the battery vertically 2.Connect the charging plug 3.Cover the pedal and
into the scooter.
and the power plug of the
controller to the battery.
fasten the silicone edge
of the pedal.
-07-
4.
Install the screws and
tighten it clockwise.
3.
When the electric scooter is sliding,
put the other foot on the pedal and
keep both feet remain stable.
-08-
4.
Continuously press the throttle to
speed up. Turn the handle to adjust
the direction.
To Next Page
Loading...