Bestech BT11NP - System Control Mode, Fan Control Mode; Temperature Adjustment; Status Indicators; Operating Your Thermostat

5
4
Operating Your Thermostat
Setting the System Control Mode
TheSystemControlhasseveralmodesofoperationthatcanbeselectedby
movingtheSYSTEMswitchtooneofthreepositions.
COOL Onlyyourcoolingsystemwilloperate
OFF Heatingandcoolingsystemsareoff.
HEAT Onlyyourheatingsystemwilloperate.
Additional Switch Position (Model BT21NP Only):
EMER Operatesabackupheatsource(EmergencyHeat)forheatpump
 systemsonly.
NOTE: If your model BT21NP was set to a con-
ventional system (NORM) then you will not have the
EMER (emergency heat) option and “NO AUX SET”
will flash in the display if EMER is selected
with the
system switch.
Setting the Fan Control Mode
The Fan Control has 2 modes of operation – AUTO and ON. The mode can
be selected by moving the FAN switch to the appropriate position.
AUTO Thesystemfanwillrunonlywhenyourheatingorcooling
  systemisrunning.
ON Thesystemfanwillstayon.
Temperature Adjustment
Presstheorbuttontoadjustthecurrentsetpointtemperature.
Status Indicators
Statusindicatorsappearinthedisplaytoletyou
knowifyoursystemisheating,coolingoroff.
HEAT Ifashing,indicatesyourheatingsystem
  isrunning.
COOL Ifashing, indicatesyourcoolingsystem
  isrunning.
Additional Status Indicators (Model BT21NP Only):
AUX Indicatesthattheauxiliarystageofheatingisrunning
  (Multi-StageSystemsonly),orthattheemergencyheat
  systemisrunning(heatpumpsystemsonly).
Resetting the Thermostat
Thisthermostatprovidesyouwitharesetbuttonthatwilleraseallofyour
usersettings.
Toresetthethermostat,useasmallobjectsuchasatoothpickorpaper-
clipandgentlypressthebuttonlocatedinsidethesmallholeonthefrontof
thethermostathousinglabeled“reset”.