YOUR ONE SOURCE
Manual Sidedrive Dual Mast Carton Sealer (MSD)
18
DAILY PREVENTATIVE MAINTENANCE
Machine Maintenance
Two-Minute Maintenance (after every shift)
In order to maintain your BestPack
®
carton sealer in top operating condition, please take two minutes
after every shift change to perform the following maintenance procedure.
1. Clean the Machine
a. Blow the machine down with dry air paying special attention to all moving parts.
2. Clean the Blade
a. Wipe down the cutting blades with a clean rag making sure to remove any glue and
plastic fi lm that may have adhered to the blade.
(i) For stubborn accumulation, spray some solvent; i.e., WD-40 or Zylene, onto a
rag to wipe the blade clean.
CAUTION ! Do NOT get WD-40 on the rubber rollers. Do NOT
use any hard objects to scrape accumulation from the
blade as it could damage the blade.
b. Wipe a thin layer of Vaseline onto the blade as your last cleaning step.
3. Water Reservoir
(applicable if the machine uses air)
a. If your carton sealer uses air, check for moisture build-up in the water reservoir.
b. If there is water in the reservoir, bleed off any moisture that has accumulated in the
water reservoir of the air regulator by pushing the button located at the bottom of the
glass container on the main regulator.
IMPORTANT SAFETY REMINDER! Remember to lockout all energy sources (i.e. power down and
shut off air supply) and release stored energy prior to servicing or moving the machine to prevent
injury
To Next Page
Loading...