YOUR ONE SOURCE
Manual Sidedrive Dual Mast Carton Sealer (MSD)
5
SAFETY PROCEDURES
1. Operators should read this manual prior to operating or making any adjustments on the machine.
2. Make sure machine power is turned off during the setup procedure while making adjustments to
the machine. Be careful with the driving direction of the conveyer.
3. Machine should not be washed down or subjected to conditions causing moisture condensation
on components and should be used in a dry, relatively clean environment at 40 to 105 degrees
Fahrenheit with dry boxes.
4. To enhance safety, operators should be alert at all times while operating the machine. When
packing products with toxic powders or chemicals, make sure packing area has good ventilation.
5. Remember to lockout all energy sources (i.e. power down and shut off air supply) and release
stored energy prior to servicing or moving the machine to prevent injury.
CAUTION LABELS
1. This label shows the entry point of the boxes. [Fig 1-1]
2. This label shows the direction of the crank handle. [Fig 1-2]
3. This label shows that that this area contains electrical components. Only authorized personnel
are allowed to access these components. [Fig 1-3]
4. Warning label cautions to keep hands out of this area due to a moving part. [Fig 1-4]
5. Warning label cautions potential electrical shock. Unplug power before servicing the machine.
[Fig 1-5]
6. Warning label cautions to keep hands out of this area because it contains a sharp knife. [Fig 1-6]
Safety
Fig 1-1 Fig 1-2
Fig 1-3 Fig 1-4 Fig 1-5 Fig 1-6
To Next Page
Loading...