BestScope International Limited
15
BS-6000A/AT
II. Mechanical Part:
1. The coarse focus knob
is hard to run
The tension adjustment collar is
too tight
Loose properly
2. The image can’t stay
on the focal plane in the
process of the
observation
The tension adjustment collar is
too loose
Tighten properly
III. Electric Part:
1. The lamp can’t light
No power supply
Check the power cord, and connect
them exactly
the installation of the bulb is
wrong
Install the bulb correctly
The bulb burn out Change a new bulb
2. The bulb burn out in a
high frequency
Not use the specified lamp Use the required lamp
3. The height of the
brightness is not enough
Not use a appointed lamp use a appointed lamp
The brightness adjustment knob
is used wrong
Adjust the brightness adjustment knob
in a correct way
4. The light glimpse
The bulb is going to spoil Change the bulb
The power cord have a poor
contact
Check the power cord, and connect
them exactly
To Previous Page
Loading...