Bestway 58500 - User Manual

Questions and Answers

F
fergusonarthurAug 5, 2025
Why does my Bestway Water Filtration System have excessive filter pressure?
- G
  Gregory BrownAug 5, 2025
  If your Bestway Water Filtration System exhibits excessive filter pressure, it could be due to a dirty filter. Try backwashing it. Alternatively, the sand bed might be calcified, requiring inspection and possible replacement. Insufficient backwashing could also be the cause; in that case, backwash until the water runs clear. Finally, the pressure gauge itself may be faulty and need replacement.
M
Matthew ColemanAug 11, 2025
What to do if there is no water flow in my Bestway 58500 Water Filtration Systems?
- E
  Elizabeth CochranAug 11, 2025
  If you're experiencing no water flow in your Bestway Water Filtration System, first, ensure that the stopper plugs have been removed and the debris screens inserted. Next, release any trapped air. Check that the control valve is set to the filter function, not closed. Also, inspect and clean the strainer if it's blocked. If none of these solutions work, the sand filter might be broken, requiring professional service.
G
grant42Aug 16, 2025
How to stop sand flowing to the pool from Bestway 58500?
- C
  cannondavidAug 16, 2025
  If sand is flowing into your pool from your Bestway Water Filtration System, it could be due to several reasons. The sand might be too fine; it's recommended to use 0.45mm to 0.85mm #20 silica sand. Another possibility is that the sand level is too high; check if it's between the marked “MAX” and “MIN” levels on the collector hub. Lastly, the skimmer could be broken and need replacement.
J
juan99Aug 23, 2025
What to do if connectors leak in Bestway 58500 Water Filtration Systems?
- T
  timothybishopAug 23, 2025
  If the connectors on your Bestway Water Filtration System are leaking, first check the position of the connector washers and reposition them if necessary. If the washer is broken, replace it. Also, inspect the O-ring on the hose connection; if it's damaged, replace it. Finally, ensure that all hoses are properly tightened.
A
alvarezaaronAug 28, 2025
Why is the control valve leaking from the port D in Bestway 58500 Water Filtration Systems?
- K
  kleinmicheleAug 28, 2025
  If the control valve on your Bestway Water Filtration System is leaking from port D, ensure that the control valve is set to only one function, not between two. If the leaking continues, the gasket may be broken and require replacement.