LaserSpeed 9000 Operator Guide
Safety Information
Part No. 93296 / Drawing No. 0921-01419 Page 6 of 16 Revision F (Feb 2013)
Safety Information
Under NO circumstances should the earth safety connections
be broken – internal damage to sensitive electronic components
may occur and at worst electrocution to personnel may result.
This equipment must be earthed/grounded.
Relays and associated wiring are rated for SELV levels i.e. 60
VDC & 30 VAC RMS. These levels must not be exceeded.
Maintenance, repairs and electrical connections should be
performed by a suitably qualified person for the country of
installation.
Input power to the equipment is of direct current type
designated by the symbol on equipment housing and shown
below.
Reference: IEC 60417-5031
The equipment contains a slow blow type fuse to protect against
input power overloads and is not user replaceable.
Intended Use
If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
To Next Page
Loading...
