EasyManua.ls Logo

Beta Marine Beta 16 - ENGINE IDENTIFICATION; Engine Identification Details

Beta Marine Beta 16
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
ENGINE IDENTIFICATION
A full inspection of the engine must be made immediately on delivery to confirm that there is no damage. If there is
any damage then write this clearly on the delivery note and inform your dealer or Beta Marine within 24 hours. A
photograph would always help.
INITIAL RECEIPT OF THE ENGINE
The engine must be stored in a dry, frost free area and this is best done in its packing case. If storage is to be more
than six months then the engine must be inhibited (contact your dealer or Beta Marine). Failure to inhibit the engine
may result in the formation of rust in the injection system and the engine bores, this could invalidate the warranty.
ENGINE STORAGE
The engine serial number is shown on the rocker cover
label. It is also stamped on the crank case flange below
the fuel injection pump on the starboard side of the
engine.
BETA 10, BETA 14, BETA 16, BETA 20 & BETA 25
3 Engine Serial Number
1 Beta Marine WOC Number
2
IMPORTANT! - We are asking you to always provide the WOC (Works Order Card)
number and or the engine serial number in all communications concerning your engine
1590_March_2014.qxd:beta 1660 manual 19/3/14 10:24 Page 4

Other manuals for Beta Marine Beta 16

Related product manuals