BETAFPV LiteRadio 3 Pro - 3. Interface and Operation; Startup Warnings and Default Screen

3. Inteace and Operation
● Boot Tips：
Power on and enter the operation inteace of the system. If the channel switch is
not at the lowest position, the remote control will show an abnormal channel
warning. Follow the prompt "Press any key to skip", press any 5-D button to skip,
or adjust the channel status to the lowest position to enter the next page.
If the remote control is not fully charged, the screen inteace will warn "RTC
Batte low", press any 5-D button according to the prompt "Press any Key" to
enter the next page.
● Default Inteace
After skipping the warning inteace, the remote control enters the default inteace.
To switch to the default inteace, push the right side 5-D button up/down.
● The remote can be set up to Sound/Vibration/Silent Mode; the default mode is
Sound+Vibration.
THROTTLE
WARNING
Press any key to skip
SA SB
THROTTLE
WARNING
RTC Battery low
Press any Key
MODEL01
SA
SB
-
-
3.7V
SC
SD
03