14
Part 3: Supplementary requirements for electro-mechanical blood
pressure measuring systems) and IEC80601-2-30 (Medical electrical
equipment – Part 2 – 30: Particular requirements for the safety and es-
sential performance of automated non-invasive blood pressure moni-
tors).
•
The accuracy of this blood pressure monitor has been carefully
checked and developed with regard to a long useful life. If using the
device for commercial medical purposes, it must be regularly tested for
accuracy by appropriate means. Precise instructions for checking ac-
curacy may be requested from the service address.
11. Mains part
Model no. FW 7575M/EU/6/06
Input 100 – 240 V, 50 – 60 Hz
Output 6 V DC, 600 mA, only in connection with beurer
blood pressure monitor.
Supplier Friwo Gerätebau GmbH
Protection This device is double insulated and protected
against short circuit and overload by a primary
thermal fuse.
Make sure to take the batteries out of the com-
partment before using the mains part.
Polarity of the the DC voltage connection
Double insulated / equipment class 2
Enclosures and
Protective Covers
Equipment enclosed to protect against contact
with live parts, and with parts which can become
live (finger, pin, hook test).
The operator shall not contact the patient and the
output plug of AC mains part simultaneously.
Subject to errors and changes
To Next Page
Loading...
