14
Unit
The device does not need any special maintenance.
Remove the battery before cleaning the device.
Clean the device with a soft, slightly moistened cloth.
Remove the battery if the device is not used for a week or more.
Store the unit with the belt in a clean, dry place.
Belt
Always detach the TENS unit from the belt after use.
If the belt has become damp during use, let it dry naturally before using again.
The belt maybe cleaned using a lightly dampened sponge. Lay the belt out flat or hang it up to
dry naturally.
Ensure the belt is completely dry before using it again.
9. Disposal
NOTICE:
Follow all laws and regulations regarding the proper disposal of batteries and electronic
•
devices that are relevant in your area. Consult your municipal authorities or your dealer
for information about proper disposal.
10. Technical Specifications
Channels Dual
Pulse Intensity Adjustable 0 – 80 mA peak into 500 ohm load each channel
Output Voltage 40 V (at 0.5 k)
50 V (at 1 k)
60 V (at 2 k)
Frequency 2 – 60 Hz
Pulse Width 156 – 260 s
Curve Shape Symmetrical biphasical wave form
Programs 8
Belt size for waist sizes from 24” to 60” (61 to 152 cm)
Power Supply 3 x 1.5 V AAA batteries
Operating Conditions 32 °F to 104 °F (0 °C to 40 °C), 20 to 90% relative humidity
Storage Conditions 14 °F to 140 °F (-10 °C to 60 °C), 20 to 93% relative humidity
Key to symbols
WARNING! Read the safety information and all
instructions to avoid serious injury.
To Next Page
Loading...
