Beurer GL44 - 6.4 Deleting Individual Measured Values from the Memory

30 Beurer GL44 mg/dL
2
After displaying the average value for 90 days “after meals”
• the average for the last seven days of values highlighted as “gen-
eral”,
• the symbol,
• the unit of measurement for blood glucose values and
• “ ”
are shown on the display.
Press “+” [6] repeatedly to display the average blood glucose level from the last 14, 30 and
90 days for values highlighted as “general”
.
3
You can cancel the process at any time. For this purpose, press the On/O button or wait
until the device switches itself o automatically after two minutes.
Tip: Speed function
You are in the measurements memory. By pressing the highlight button [3], you can switch to the
dierent 7-day average values. In this way, you can get to the desired average value more quickly.
For example:
6.4 Deleting individual measured values from the memory
1
Press the buttons as described in 6.1 until the value appears that you would like to delete.
2
Press and hold the On/O button. Additionally press the “–” button for two seconds.
“ ”, “Mem” and the number of the value to be deleted flash.
Press the On/O button again. “ ”, the number of the value to be deleted, “Mem” and “ ”
are displayed.
If you do not wish to delete the value, briefly press the “+” or “–” button. You are taken back
to the memory spaces.
3
The device subsequently displays that the following measured value has moved to the memory
space of the deleted measured value.